Base Kit Components 753H

These components are subject to change based upon your selections.

Compatible Vehicles

These vehicles also are compatible with this product.
Click on a vehicle to see other available kits.

Email Summary

Important Kit Notes

• - For DRW models, use the w/ overload rear lift option
• - Requires frame bracket modification.
• - Torsion Bar Tool required to load/unload torsion bars, The GM specified tool is #CH48809.
• - Models with two-piece rear driveshafts will require a carrier bearing drop kit.
• - Factory 17-18" wheels cannot be reinstalled due to tie rod end interference, stock 20" wheels can be reinstalled with up to a 35x12.50 tire.
• - In some cases vehicles used in 4WD on the highway regularly could potentially experience a minor front driveline vibration. If this occurs we recommend replacing the front driveshaft with a dual Cardan style driveshaft.
• - Do not install this suspension system in conjunction with any type of torsion bar lift keys to achieve more that tested 6.5" lift height.
• - Compatible with gas or diesel models.
• - Compatible with standard models as well as AT4 models.
• - Some minor trim will be required with certain wheel/tire combination. This is normal with most aftermarket tire/wheel fitment on Chevy/GM trucks. Trimming will normally included the bottom edge of the inner fender shrouds and/or lower corner of front bumper valance. As a rule of thumb, deeper backspacing and shorter/narrower tires will reduce/eliminate trimming required.
• - Further trimming tips are included at the end of this instruction sheet.